Advertisement
52
Chapter VI—Power Take-Off
Torque Wrench
RM-655
Fig. 49—Checking Bearing Preload
163.
ASSEMBLY.
To assemble the power take-off adapter, position the sleeve on the
shaft, and secure it to the shaft with a rivet (fig. 47). Install the
bearing and shaft assembly in the housing with the sleeve end of the
shaft towards the rear of the housing (fig. 47). Press the oil seal
(fig. 47) in the bearing retainer. Install the bearing retainer, shims,
and guard on the housing. Adjust the preload to 5 to 12 pounds-
inches by increasing the shim
pack to reduce
the preload
or by
decreasing the shim pack to increase the preload.
To assemble the power take-off shaft assembly, press the oil seal
(fig. 48) in the cover. Press the cover assembly onto the shaft and
bearing. Install the rear snap ring in the cover. Install the cover cap.
§ 163.
3730-473
Advertisement
