Ford Tractor 8N Service Manual page 40

Section 151—Disassembly 39
Chapfer
V
REAR AXLE
Section
DigesSe MI DIy scr cesta, scsi ees 4 cece WY RE we = . a l t o s , S&S Ghee 151
Inspection and Repair........ (Rants U R k o d WM & ae we Aanate 152
Asser Dy nis 5 ties ane aeeees 4 Haee be Sacea imesreeseeas LOS
151. DISASSEMBLY.
To disassemble the axle, remove the axle shaft nut lock ring, and
remove the axle shaft nut, flat washer, and seal (fig. 34). Remove
the hub from the axle shaft (fig. 33). Remove the cap screws and
nuts that secure the brake support plate to the axle shaft housing,
and remove the brake support plate assembly. Remove the oil seal
retainer from the bearing retainer (fig. 34). Repeat this procedure
to remove the other brake support plate. Remove the brake dust
shield assembly and the oil seal. Be sure to keep the shim pack
intact to facilitate reassembly.
Lift the axle shafts from the axle housing. Remove the nuts that
secure the left-hand axle housing to the center housing, and remove
the axle housing. Lift the differential from the center housing (fig.
35). Remove the right-hand axle housing from the center housing.
By a — ROCKER
BACKING PLATE
BRAKE CAM SHAFT
™~ CENTER HOUSING
DRIVE PINION
BRAKE PEDAL
RM-596
Fig. 32—Rear Axle Assembly
3730-473 § 151.