Advertisement
Section 162—Inspection and Repair
51
LUBRICATOR FITTING—353027-A3-S7-8
GUARD— 230020
ri
SHIMS— 230018
SEAL— 230017
BEARING
CUP— 230012
OUSING— 230011
=
—e
CONE— 23001 \
a
é
2)
4) 4
$ a,
=)
BOLT— 20470-S7-8
SONER
a A008
Shea. 230015
—2
LOCK
WASHER—34808-S7-8
SHAT
280014
Pa 60577-S7-8
RM-645
Fig. 47—Power Take-off Adapter, Disassembled
(2) SHAFT.
Replace the shaft (fig. 47) if it is broken or if the
splines are worn or damaged.
(3) SLEEVE.
Replace the sleeve if the splines are worn or dam-
aged.
(4) BEARING.
Replace the bearing (fig. 47) if any of the rollers
are missing, if they have flat spots, or if the surfaces are pitted or
corroded. Separate the bearings with a bearing wedge and remove
them with a puller as shown in figs. 45 and 46.
(5) BEARING
RACE.
Replace
a bearing
race
that is scored,
worn or pitted,
(6) HOUSING.
Replace
the housing if it is cracked
or if the
threads are stripped.
b. Power
Take-off
Shaft.
Replace the shaft and bearing as-
sembly (fig. 48) if the splines are damaged, if the bearing is scored,
or corroded, if the bearing race is loose, or if the oil and dust seal
surfaces are damaged.
Always
replace the oil seal if it has been
removed.
CAP—726
SLEEVE—756
ae oe
SHAFT—725
ia
SNAP RING— :
RM-648
Fig. 48—Power Take-off Shaft, Disassembled
3730-473
§ 162. b.
Advertisement
