Advertisement
50
Chapter VI—Power Take-Off
Bearing Wedge
POWER
TAKE-OFF ADAPTOR
SHAFT
RM-657
Fig. 45—Separating Power Take-off Adapter Shaft Bearings
b. Power Take-off Shaft. Remove the snap ring from the rear
of the bearing. Press the shaft and bearing assembly from the power
take-off cover. Press the dust and oil seal out of the power take-off
cover (fig. 48).
162.
INSPECTION
AND
REPAIR.
Clean
all parts thoroughly
in cleaning
fluid.
Discard
all used
gaskets and oil seals.
a. Power
Take-off Adapter.
The adapter assembly comprises
the guard, shaft, sleeve, bearing, bearing race, and housing.
(1) GUARD.
Replace the guard (fig. 47) if it is distorted or bent
beyond repair.
Bearing Wedge
a
Fig. 46—Removing Power Take-off Adapter Shaft Bearings
§ 162. a. (1)
3730-473
RM-646
Advertisement
