Advertisement
22
Chapter Il—Transmission
TRANSMISSION
COVER—7211
SPRING
RETAINER— 7228
| SPRING—7227
STARTER
BUTTON— 11500
LOCKWASHER—351217-S
Y LATCH—725
SHIFTER
LOCK—7229
SAFET
CH—7257
RM.608
Fig. 15—Transmission Cover, Disassembled
(55T) and roller bearing off the countershaft. Lift the countershaft
fourth gear (36T) and sliding coupling from the countershaft (fig. 12).
Remove the countershaft coupling from the countershaft with a gear
puller or press. Lift the countershaft second gear (18T) from the shaft.
(3) REVERSE
IDLER
GEAR
ASSEMBLY.
Remove
the re-
verse gear coupling from the reverse idler gear and bushing assembly
(fig. 13). Remove the snap ring, thrust washer, and reverse idler gear
and bushing assembly.
(4) POWER
TAKE-OFF SHIFTER
ASSEMBLY.
Remove the
snap ring from the rear of the bearing support (fig. 14). Lift the bear-
ing and clutch sleeve from the bearing support. Remove the nut and
lock washer from the shift rail, and remove the shift rail toward the
rear, being careful not to lose the interlock ball and spring. Lift out
the shift fork.
(5) TRANSMISSION COVER. Slide the shift lever rubber boot
up on the lever. Remove the starter switch. Compress the gearshift
lever spring, and remove the horseshoe-type spring retainer, Pull up
on the gearshift lever and, by turning it 90°, lift it out of the assem-
bly. Tilt the safety latch plate and remove it from the guide support
(fig. 15). Drive the pin from the gearshift lever, and lift off the lever.
§ 131. b. (5)
3730-473
Advertisement
