Table of Contents
Advertisement
Vehicles with rear-wheel drive
Jack support points
Only use the middle rod and the pump handle rod
with the largest diameter for the jack as a wheel
wrench extension. Only fit the middle rod on the
wheel wrench, and always as far as it will go. Oth-
erwise, the rods could bend and deform so much
that they can no longer be used as pump handles
for the jack.
To prepare the hydraulic jack: Insert the third
#
rod of the jack's pump handle
wheel wrench extension.
Close the pressure release screw 3.
#
To do this, use the flattened section on the
#
pump handle
1
to turn the pressure release
3
screw
clockwise to the stop.
%
Do not turn the pressure release screw
more than one or two full turns. Hydraulic fluid
could otherwise escape.
Insert the pump handle
#
pointing forward into the recess on the jack
and secure by turning it clockwise.
Place the jack vertically beneath the jack sup-
#
port points described below.
Jack support point, front axle
Jack support point, rear axle
Place the jack beneath the jack support point.
#
Raise the vehicle until the tire is a maximum of
#
1
into the
1.2 in (3 cm) off the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
3
When changing a wheel, avoid applying any force
to the brake discs since this could impair the level
of comfort when braking.
Wheels and tires 209
1
with the largest rod
page 209).
/
page 208).
/
Advertisement
Table of Contents
