Advertisement
BATTERY REPLACEMENT
(1)
Loosen the thumb screw on the pedal to
open it.
(2)
Take out the battery from the battery
housing and disconnect the battery snap.
(3) Connect a new battery to the battery snap,
then replace the battery in to the battery
housing,
* Make sure that the polarity of the battery
is correct,
(4) Push the coil spring into the spring base on
the rear of the pedal, then close the pedal.
* Make sure that the snap cord is not caught
in the pedal or coil spring.
(5) Insert the thumb screw into the guide bush
hole and firmly tighten the screw.
The type of battery to use is: 006/9 V (one).
Pedal
Battery Snap Cord
Thumb Screw
Housing
SETTING MEMO
IMPORTANT NOTES
-Do not subject the unit to temperature extremes
{eg. direct sunlight in an enclosed vehicle). Avoid
using or storing the unit in dusty or humid areas or
areas that are subject to high vibration levels.
-Remove the battery whenever the unit is not going
to be used for an extended period of time.
-When operating solely on a battery, the unit's
indicator becomes
dim when
the battery is
depleted. Replace the batlery immediately.
~if there is a battery in the unit while an AC adaptor
is being used, normal operation will continue
should the line voltage be interrupted(power
blackout)
or
the
power
cord
become
disconnected.
-Should a malfunction occur (or if you suspect there
is a problem) discontinue use immediately. Contact
qualified service personnel as soon as possible.
wes
@OUT:9VDC/200mA
Advertisement
