Fcc, Acta And Ic Regulations - VTech t2429 Owner's Manual

FCC, ACTA and IC Regulations

This equipment complies with Parts 15 of the Federal Communications
Commission (FCC) rules for the United States.It also complies with regulations RSS210
and CS-03 of Industry and Science Canada. Operation is subject to the following two
conditions: (1) this device may not cause interference,and (2) this device must accept
any interference, including interference that may cause undesired operation of the
device.
A label is located on the underside of the Base Unit containing either the FCC registra-
tion number and Ringer Equivalence Number (REN) or the IC registration numberand
Load Number. You must, upon request, provide this information to your local tele-
phone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
VTech Communications Inc
CUSTOMER SERVICE. at1-800-595-9511.In Canada, call VTech Telecommunications
Canada Ltd. at 1-800-267-7377.
For repair/warranty information, the telephone company may ask you to disconnect
this equipment from the line network until the problem has been corrected.
FCC Part 15
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equiment.
The equipment has been tested and found to comply with part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.However, there is no
guarantee that interference will not occur in a particular installation. If this equiment
does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68 and ACTA
If this equipment was approved for connection to the telephone network prior to July
23, 2001, it complies with Part 68 of the Federal Communications Commission (FCC)
rules. If the equipment was approved after that date, it complies with the Part 68 rules
and with Technical Requirements for Connection of Equipment to the Tele-
phone Network adopted by the Administrative Council for Terminal Attachments
(ACTA). We are required to provide you with the following information.
25
91-000132-020-000.t2429 English manual (R1).pmd 25 12/29/2004, 5:27 PM