Getting Started; Installation; Before You Install - VTech t2429 Owner's Manual

Installation

Before You Install

1. Choose a location for the base near an electrical outlet and a telephone jack. This
phone requires a modular telephone jack and a standard electrical outlet (110v
AC) not controlled by a wall switch. Plug the AC power adaptor into the electrical
outlet and the DC connector to the jack on the bottom of the base unit.
2. Install the handset battery. Use only the battery provided or recommended by
VTech.
3. Attach the belt clip to the cordless handset (optional).
NOTE: Install the base unit away from electronic equipment, such as personal
computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or
moisture
.
Table/Desk Installation
4. Charge the Handset Battery
Place the handset in the base. Charge the battery at least for 24 hours the first time.
5. Check for Dial Tone
After the batteries are charged, connect the modular telephone cord between a
live phone jack and the jack located on the bottom of the base unit. Pick up the
handset and press PHONE. You should hear a dial tone.
91-000132-020-000.t2429 English manual (R1).pmd
a) Remove battery
compartment cover
by pressing on the
indentation and
sliding downward.
b) Align the two holes in the plug with
the socket pins, then snap the plug
into place.
c) Place the battery in the compartment
with the wires in one of the
owercorner.as shown in the picture
on the left.
d) Replace cover by sliding it up into
place,
To attach
4
4
To remove
12/29/2004, 5:27 PM