HP Z Series Maintenance And Service Manual page 85

Table 7-1 POST numeric codes and text messages (continued)
Control panel message
00D-Setup Error during MEBx Execution
00E-Inventory Error during MEBx
Execution
00F-Interface Error during MEBx
Execution
100-Front Audio Not Connected
2E1-MemorySize Error
2E2-Memory Error
2E3-Incompatible Memory Module in
Memory Socket(s) X, X, ...
2E4-DIMM Configuration Warning
Description
MEBx selection or exit resulted in a setup
failure.
BIOS information passed to the MEBx
resulted in a failure.
MEBx operation experienced a hardware
error during communication with the ME.
Front audio cable has been detached or
unseated from system board.
Memory amount has changed since the
last boot (memory added or removed).
Memory module configuration failed
during boot up.
A memory module in memory socket
identified in the error message is
missing critical SPD information, or is
incompatible with the chipset.
Populated DIMM Configuration is not
optimized.
Recommended action
1. Reboot the computer.
2. Unplug the power cord, reseat the
memory modules, and reboot the
computer.
3. If the memory configuration was
recently changed, unplug the power
cord, restore the original memory
configuration, and reboot the
computer.
4. If the error persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the
latest BIOS version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the
latest BIOS version.
3. If the error still persists, replace the
system board.
Reconnect or replace front audio cable.
The system memory size is different
from the last startup. The most common
reason is the removal of memory from
the system board. Press the
save the memory changes.
1. Be sure that memory modules are
correctly installed.
2. Verify proper memory module type.
3. Remove and replace the identified
faulty memory modules.
4. If the error persists after replacing
memory modules, replace the
system board.
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace with a supported module.
Rearrange the DIMMs so that each
channel has the same amount of
memory.
POST numeric codes and text messages
f1 key to
77