Gree GWH09AOCXD-K6DNA1B Service Manual page 59

Step
6. Remove front case assy
a. Disconnect the wiring terminal of up&down swing
motor;
b. Remove the 6 fastening screws as shown in the
figure;
c. Break off the 4 clasps of front case as shown in the
figure;
d. Remove the front case.
7. Remove swing motor and drive box
a. Remove the filter;
b. Remove the 4 fastening screws as shown in the
figure;
c. Remove the swing motor;
d. Remove the drive box.
8. Remove transmission rod sub-assy
Make the transmission rod sub-assy out of the slot
in the middle of the front case, and then pull out the
transmission rod sub-assy from the right.
56
Procedure
Front case
Clasp of front case
Fastening screw
Transmission
rod sub-assy
Service Manual
Swing motor
Fastening screw Drive box
Installation and Maintenance