Table of Contents
Advertisement
4. Reassemble the filtering unit after
cleaning:
a. Slide the long life carbon filters into
the hood system along the built-in
runners.
b. Place the grease filter housing back
inside.
c. Place the grid back on.
Cleaning the grease filters and the
grease filter housing
1. Wash the grease filter housing with the
grease filters carefully in warm water
using a mild cleaning agent, then rinse it
with warm water. You can use a soft
sponge, a soft cloth, or a non-abrasive
cleaning brush to remove food remains, if
necessary.
Wash the grease filters and the grease
filter housing in the dishwasher on any
standard cycle.
Depending on the detergent type and
the number of dishwasher cycles,
some mild discolouration on the
mesh may naturally occur. This does
not affect the performance of the
grease filter.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
It is not recommended to use paper
towels while cleaning / drying the filtering
components.
2. Leave it for some time to dry at room
temperature.
3. Put the grease filter housing with the
grease filters back inside.
4. If the notification
briefly to reset the counter.
The counter restarts.
Cleaning the long life carbon filters
1. Wash the filters carefully in warm water
without any cleaning agents. Detergents
can damage the carbon filtration. You can
use a soft sponge, a soft cloth, or a non-
abrasive cleaning brush to remove food
remains, if necessary. Alternatively, after
removing heavier dirt from the filters, you
can also wash the filters in a dishwasher
at 65-70 °C (using a program longer than
90 min), without detergents and without
dishes in the same load.
2. Leave the filters to dry overnight at room
temperature. The filters need to be fully
dried before reassembly.
3. Reassemble the filtering unit and put it
back inside.
Regenerating the long life carbon
filters
1. Clean the filters first, as described above.
2. Put the filters in the oven set to 100 °C for
120 min. Place the filters on the middle
wire shelf. Use a non-fan oven function.
3. Reassemble the filtering unit and put it
back inside.
4. Press
briefly to reset the counter.
The counter restarts.
is on, press
ENGLISH
23
Advertisement
Table of Contents
