Troubleshooting - AEG CDE84779XB User Manual

26 www.aeg.com
you can leave the filter to dry
overnight at room temperature. The
filter needs to be fully dried before
reassembly.
3. Reassemble the filtering unit and put
it back inside the hood cavity.

10. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
You cannot activate or op‐
erate the hob.
You can hear a constant
beep noise.
You cannot select the
maximum heat setting for
one of the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
4. If the notification
The counter restarts.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You did not set the heat set‐
ting for 60 seconds.
You touched 2 or more sen‐
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
The electrical connection is
incorrect.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
You put something on one or
more sensor fields.
is blinking, press
briefly to reset the counter.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Activate the hob again and set
the heat setting in less than 60
seconds.
Touch only one sensor field.
Refer to "Pause".
Clean the control panel.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the in‐
stallation.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase. Refer
to "Power management".
Remove the object from the
sensor fields.