Table of Contents
Advertisement
3. INSTALLATION
WARNING!
Refer to Safety chapters.
3.1 Before the installation
Before you install the hob, write down the
information below from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
3.2 Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
3.3 Attaching the seal
On-top installation
1. Clean the worktop around the cut out
area.
2. Attach the supplied 2x6 mm seal stripe to
the lower edge of the hob, along the outer
edge of the glass ceramic. Do not stretch
it. Make sure that the ends of the seal
stripe are located in the middle of one
side of the hob.
3. Add some millimetres to the length when
you cut the seal stripe.
4. Join the two ends of the seal stripe
together.
8
ENGLISH
Integrated installation
1. Clean the rabbets in the worktop.
2. Cut the supplied 3x10 mm seal stripe into
four stripes. The stripes must have the
same length as the rabbets.
3. Cut the ends of the stripes at an angle of
45°. They should fit in the corners of the
rabbets accurately.
4. Attach the stripes to the rabbets. Do not
stretch the stripes. Do not bond the ends
of the stripes one over the other.
After you assemble the hob, seal the
remaining gap between the glass ceramic
and the worktop with silicone. Make sure the
silicone does not get under the glass ceramic.
3.4 Assembly
Refer to the installation booklet for detailed
information on how to assemble your hob.
Follow the hob connection diagram and the
window switch connection diagram (if
applicable) presented in the installation
booklet and / or the labels under the hob.
Only for selected countries
In case of exhaust installation a window
switch might be required (consult an
authorised technician). You need to buy it
separately as it is not supplied with the
hob. The window switch has to be
installed by an authorised technician.
Refer to the installation booklet.
Advertisement
Table of Contents
