Operation - Makita HR009GZ01 Instruction Manual

2. Lift the lock tab slightly outwards and open the
filter cover of the dust case.
1
Fig.44
► 1 . Filter cover 2. Lock tab
Remove the filter from the filter case.
3.
Fig.45
► 1 . Filter 2. Filter case
Attach a new filter to the filter case, and then
4.
attach the filter cover.
5. Close the cover of the dust case, and then attach
the dust case to the dust collection system.
Replacing sealing cap
A damaged or worn-out sealing cap may affect the dust
collecting performance. Replace the sealing cap with
new one as appropriate, aligning its guide projection
with guide notch on the nozzle head.
1
Fig.46
► 1 . Sealing cap 2. Guide projection 3. Nozzle head
4. Guide notch
2
1
2
3
4
2
20 ENGLISH
Storage
NOTICE:
When not in use for a certain period of
time, the nozzle guide needs to be extended to
approximately 100 mm from its fully shortened
position. Failing to do so may damage the duct hose
pre-installed in the nozzle guide.
2
Fig.47
► 1 . Guide adjustment button 2. Approx. 100 mm

OPERATION

CAUTION:
Always use the side grip (auxiliary
handle) and firmly hold the tool by both side grip
and switch handle during operations.
CAUTION:
Always make sure that the work-
piece is secured before operation.
CAUTION:
Do not pull the tool out forcibly
even the bit gets stuck. Loss of control may
cause injury.
NOTICE:
Before using the dust collection sys-
tem with the tool, read the section about the dust
collection system.
NOTE: If the battery cartridge is in low temperature,
the tool's capability may not be fully obtained. In this
case, warm up the battery cartridge by using the
tool with no load for a while to fully obtain the tool's
capability.
Fig.48
1