Evenflo Omni Plus - Modular Travel System with LiteMax Sport Rear-Facing Infant Car Seat Manual

Also See for Omni Plus:

Manual (29 pages)

Instructions manual (68 pages)

Table of Contents

Contents

1 FEATURES
2 IMPORTANT INFORMATION
3 IDENTIFICATION OF PARTS
4 CHOOSING MODE OF USE
5 ASSEMBLING YOUR PRODUCT
6 USING YOUR PRODUCT
7 USING YOUR UNIT WITH THE RECOMMENDED INFANT CAR SEATS ON YOUR UNIT FRAME
8 CARE AND MAINTENANCE
9 SAFETY
10 LIMITED WARRANTY
11 Documents / Resources
- 11.1 References
- 11.2 Download manual

Evenflo Omni Plus - Modular Travel System with LiteMax Sport Rear-Facing Infant Car Seat Manual

FEATURES

STROLLER
Up to 50 lbs (22.6 kg)
Up to 40 in (101.6 cm)

FEATURES

Canopy
Parent's Handle
Fold Latch
Cupholder
Toddler Seat Release Button
Side Frame Lock
Swivel Wheel
Footrest
Buckle
Harness Covers (only on certain models)
Bumper Bar
Shoulder Straps
Multi-Position Recline Handle
Multi-Position Recline Strap
Storage Basket
Brakes

IMPORTANT INFORMATION

Child Requirements - When stroller is in carriage mode, it is intended for a child up to 6 months of age. Only use the stroller in the upright position with a child who is capable of sitting upright unassisted.

Maximum weight: 50 lbs (22.6 kg)
Maximum height: 40 inches (101.6 cm)

Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble the stroller according to these instructions. If you are missing parts, do not use stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971 (Canada), or 800-706-1200 (México) to order replacement parts.

Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal information. To register your product, please complete and mail the card that came with it or visit our online registration at www.evenflo.com/registerproduct.

For future reference, record the Model Number and Date of Manufacture. You can find this information on one of the rear stroller legs.

IDENTIFICATION OF PARTS

CHOOSING MODE OF USE

YOUR STROLLER SEAT CAN BE USED IN TWO DIFFERENT MODES.
TODDLER SEAT MODE OR CARRIAGE MODE.
Your stroller seat is shipped in carriage mode with the buckles unfastened under the footrest. You will need to follow the instructions completely to make sure you set up your stroller in your preferred mode of use.
After the frame and the wheels have been assembled, you can choose to set the stroller up in Carriage Mode or Toddler Seat Mode by following instructions below.
CHOOSING MODE OF USE

ASSEMBLING YOUR PRODUCT

FRAME

DEATH or SERIOUS INJURY can occur.
Care must be taken when folding or unfolding stroller to prevent finger injury in hinge areas.

To protect flooring, place a protective covering (carton) beneath the stroller during assembly.
Unlatch side frame lock. Continue holding the lock open while unfolding the stroller.
Grab the parent's handle and pull upward until the stroller opens fully with an audible click.
Make sure the stroller locks in the open position by pushing down on the parent's handle.

WHEELS

To attach front wheels, push wheel onto front leg tube until it clicks into place. Repeat on other side.
Pull on wheels to make sure both of them are attached.
To attach rear wheels, push wheels onto rear leg tubes until they click into place.
Pull on wheels to make sure both of them are attached.

TODDLER SEAT MODE

To set up seat in toddler seat mode, flip toddler seat over and attach the buckle on the seat as shown.
Turn seat back over and attach toddler seat to the mounts until they both click into place on both sides of the frame.
CHECK to make sure it is securely attached by pulling up on it.
The toddler seat may be attached forward or rear-facing.
NOTE: Stroller cannot be folded with seat in rear-facing position.
To attach bumper bar, push tabs into openings on stroller on either side of frame until it clicks into place.
Pull on the bumper bar to make sure it is locked into place.
To remove the bumper bar, push both tabs and remove the bumper bar from the stroller.
To recline toddler seat, lift handle and rotate to desired position.
To remove toddler seat from frame, press levers on both sides of stroller and lift seat off stroller.

USING YOUR PRODUCT

SETTING UP THE UNIT IN CARRIAGE MODE FROM TODDLER SEAT MODE

DEATH or SERIOUS INJURY can occur.

NEVER use seat in a reclined carriage position unless straps under seat are unbuckled and seat is set up in reclined carriage mode as per the instructions.

If you are in Toddler Seat Mode as shown, follow these steps to convert to Carriage Mode.
To recline seat, squeeze button and pull down the recline strap on the rear of seat.
Unfasten buckle behind leg rest on toddler seat. Refer to "TODDLER SEAT MODE" Step 1, for buckle location.
Lift handle and rotate seat all the way down so that it is flat.
Press down on the inside of the toddler seat to flatten out the inside.

DEATH or SERIOUS INJURY can occur.
NEVER lift or carry toddler seat by the bumper bar.

To remove and use in rear facing mode: depress the release buttons on both sides of toddler seat, lift seat off stroller frame and turn it around and re-attach.
CHECK to make sure it is securely attached on both sides by pulling up on it.

BRAKES

DEATH or SERIOUS INJURY can occur.

ALWAYS lock both brakes. Make sure brakes are on by trying to push the stroller.

To lock, press lever DOWN on both rear wheels.
To unlock, press lever UP on both rear wheels.

CUPHOLDER

To attach cup holder, slide down on the mount as shown.
To remove cupholder, press tab towards center and slide up as shown.

HARNESS

DEATH or SERIOUS INJURY can occur.

To avoid serious injury from falling or sliding out, ALWAYS use waist restraint.

NOTE: Verify the stroller is locked in the open position by lifting up the rear of the stroller using the parent's handle.

Lock the rear brakes and remove the bumper bar.
The harness shoulder straps must be at shoulder height or lower, closest to the baby's shoulders .

Place the baby in the seat and bring the crotch panel up between the child's legs. Fasten each buckle . For a snug, comfortable fit, pull the shoulder straps to tighten the shoulder restraint and pull the waist restraint straps to tighten the waist restraint.

NOTE: To loosen the waist straps , push in the release button on the buckle and pull.

To loosen shoulder straps push up on the retainer while pulling down on the shoulder strap.

Once the child is properly restrained, re-attach the bumper bar.
Make sure the bumper bar locks into position with audible clicks.
Pull on the bumper bar to make sure it is locked into place.

CANOPY

To open or close canopy, push to the front or the rear of the stroller.
Canopy has a window that can be rolled back so you can view child.
To remove canopy, unfasten canopy mounts from sides of toddler seat as shown.
Unfasten hook and loop tape from top edge of canopy as shown. Repeat on other side of canopy.

FOLDING THE UNIT

DEATH or SERIOUS INJURY can occur.
Care must be taken when folding or unfolding stroller to prevent finger injury in hinge areas.

To fold the stroller, adjust seat back to upright position, lock the rear brakes, close the canopy, and remove your child.
Pull the levers on both sides of the stroller and lower frame until the side frame lock clicks into place.
FOLDING THE UNIT

NOTE: Stroller cannot be folded with seat in rear-facing position.

For more compact fold, you can remove the toddler seat before folding the stroller frame.
NEVER fold the stroller when the toddler seat is in the carriage mode.

USING YOUR UNIT WITH THE RECOMMENDED INFANT CAR SEATS ON YOUR UNIT FRAME

DEATH or SERIOUS INJURY can occur.

Only use Evenflo SafeMax infant car seats or any version of the LiteMax infant car seat with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and if used with this stroller may result in serious injury to your child.
Before using the infant car seat with this stroller, read all the instructions provided with it and keep the instructions stored properly for future use.
DO NOT lift stroller by using the infant car seat handle when installed on stroller.
If unable to securely attach your infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink at 1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 800-706-1200 ( México ).
To avoid serious injury, make sure the infant car seat is securely snapped onto the car seat mounts.
Some Evenflo SafeMax and LiteMax infant car seats have a blanket/boot option that must be removed for proper attachment to this stroller.

To remove the toddler seat, press the release buttons down on either side of the toddler seat and lift seat off stroller frame.
To attach car seat, insert car seat into the mounts until they both click into place on both sides of the frame.

USING INFANT CAR SEATS ON YOUR UNIT FRAME - Step 3
NOTE: The infant car seat may be installed facing the parent or facing forward on the stroller frame.

Pull up on the front and back of the infant car seat to test that it is properly locked into place.
TO REMOVE, squeeze handle on rear of seat and pull car seat up off of the stroller.

CARE AND MAINTENANCE

Clean minor spills and stains on cloth or plastic surfaces with cold water and mild soap. Air dry.
Metal and plastic parts can be wiped clean with a soft damp cloth and dried with a soft cloth. DO NOT use abrasive cleaners or solvents.

SAFETY

READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS!
FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!

Only use Evenflo SafeMax and LiteMax infant car seats with this stroller.
Other infant car seats or carriers are not designed to fit the stroller frame unless specified in the instructions. If any car seats are used that are not specified in the instructions this may result in serious injury to your child.
NEVER leave child unattended. ALWAYS keep child in view while in the stroller.
Adult assembly required. Take care when unpacking and assembling; contains small parts and some items with sharp edges.
To prevent a possible choking hazard, remove and discard packing material before using this product.
Avoid serious injury from falling or sliding out. ALWAYS use waist restraint.
DO NOTcarry or roll stroller on stairs or escalators with child in it.
DO NOT hang items on handle bar or place them on the canopy as they can tip stroller over and injure child.
Be sure stroller is fully assembled and locked in unfolded position before using.
ALWAYS exercise care when going over curbs or steps, and never use stroller for anything other than transporting your child. Push stroller at a normal walking pace only; faster strolling can cause a loss of control and injury to the child.
DO NOT place hot liquids in cup holder. Spills can burn you or your child.
To avoid serious injury from child falling out of stroller, DO NOT raise or recline seat with child in stroller.
DO NOT use stroller if any parts are missing or broken.
DO NOT allow child to climb on, into, out of, or around stroller.
DO NOT allow child to stand on the footrest. Stroller may tip over and injure child.
DO NOT carry additional children, goods, or accessories in or on this stroller except as advised in these instructions. The stroller is intended for use with one child and to accommodate only the additional weights in storage as listed in these instructions.
Care must be taken when folding or unfolding stroller to prevent finger injury to you or your child in hinge areas. Make sure child is not in the seat or near the stroller when folding or unfolding.
NEVER leave stroller on a hill or incline, even with brakes set. Stroller may tip, injuring the child.
To avoid accidental rolling, ALWAYS set brakes when stroller is not being pushed.
AVOID STRANGULATION:
- DO NOT suspend strings or toys from the canopy.
- DO NOT place stroller anywhere near cords from window blinds, draperies, phone, etc.
- DO NOT place items with a string around your child's neck such as hood strings or pacifier cords.
- If not properly secured, the child may slip into leg openings and strangle.
When making adjustments to the stroller, ALWAYS ensure that all parts of the child's body are clear of any moving parts of the stroller.
The canopy is not intended to provide UV protection.
Sharp or heavy objects placed in pockets may cause damage to the stroller, or injury to the child.
To ensure safety for your baby, please refer to the manufacturer's instructions for the use of your recommended infant car seats and keep all instructions available for reference.
DO NOT lift stroller by using the infant car seat handle when installed on stroller.
If unable to securely attach the infant car seat to this stroller, remove the car seat and contactEvenflo ParentLink at 1-800-233-5921 (USA), 1-937-773-3971 (Canada), or 800-706-1200 (México).
To avoid stroller instability and tip-overs,DO NOT load cup holder with over 1 lb (0.45 kg), and the main cargo basket with over 10 lbs (4.5 kg).
NEVER use the toddler seat without the canopy attached.
NEVER lift or carry the toddler seat by the bumper bar.
NEVER use the stroller frame without the toddler seat or car seat attached.
NEVER use toddler seat in a motor vehicle or use it as a booster seat.
To avoid falls, never remove toddler seat from the stroller with child in it.
To avoid falls, always make sure the toddler seat or car seat is securely attached into the seat mounts on both sides of the stroller before placing child in the seat.
When stroller seat is in carriage mode, it is intended for a child up to 6 months of age.
NEVER use seat in the carriage mode position unless the straps under the seat are unbuckled and the seat is set up in carriage mode as per the instructions.