Evenflo Clover, Clover Sport - Travel System with LiteMax Infant Car Seat Manual

Identification of Parts

Features

Choosing Mode of Use

Your stroller can be used in two different modes: Comfort Mode or Stroller Mode.
Your stroller is shipped in Stroller Mode. You will need to follow the instructions completely to make sure you set up your stroller in your preferred mode of use.
After the frame and the wheels have been assembled, you can choose to set the stroller up in Comfort Mode or Stroller Mode.

Assembling Your Stroller

DEATH or SERIOUS INJURY can occur.
Care must be taken when folding or unfolding stroller to prevent hand or finger injury in hinge areas.

FRAME
To protect flooring, place a protective covering beneath the stroller during assembly.

Unlatch side frame lock. Continue holding the lock open while unfolding the stroller.

Grab the parent's handle and pull upward until the stroller opens fully with an audible click.

Make sure the stroller locks in the open position by pushing down on the parent's handle.

FRONT WHEEL ASSEMBLY

To attach front wheels, turn stroller over so front leg tube is positioned as shown and insert front wheel until it clicks into place. Repeat on other side.
Pull on wheels to make sure both of them are securely attached.

REAR WHEEL ASSEMBLY

To attach rear wheel, remove the hairpin (A) and one washer (B) from the axle assembly.

Attach wheel, then re-attach washer (B) to the axle.

Push straight side of pin through axle hole. Pin will separate around the axle.
NOTE: Use needle nose pliers to hold pin for easier assembly.

Attach hubcap to wheel until it clicks into place once the washer and hairpin are attached.

To attach rear wheel assembly to stroller, turn stroller over so back tube is positioned as shown. Push wheels onto rear leg tubes until they click into place.
Pull on wheels to make sure both of them are securely attached.

CHILD TRAY
To attach child tray, slide tray onto tabs on both sides of the stroller until they click into place.
Pull up on both sides of tray to make sure it is securely attached.

To remove child tray, squeeze levers under both sides of tray and pull up from stroller.

Using Your Stroller

CANOPY

To open canopy, pull forward.

To close, push to the rear of stroller.

To access canopy window, pull flap forward as shown.

To access canopy visor, if included, pull flap forward as shown.*

*Not all features are available on all models. Styles may vary.

DEATH or SERIOUS INJURY can occur.
Always lock both brakes. Make sure brakes are on by trying to push the stroller.

BRAKES
To lock, press lever DOWN on both rear wheels.

To unlock, pull lever UP on both rear wheels.

HARNESS
To secure harness, click harness connectors into the center buckle.

To unlock harness, push the button on the center buckle.

To adjust harness around your child, tighten shoulder and waist straps as shown.
Repeat with other harness strap.

Wrap harness covers, if available, around the harness straps as shown.*

To change shoulder strap height positions, reach one hand behind stroller and push retainer out to the front of the seat then reinsert into the desired set of slots that are closest to your child's shoulder. MAKE SURE retainer goes through boards and fabric.
Repeat with other harness strap.
When re-inserting harness straps, MAKE SURE to always place harness straps at the same height setting.

*Not all features are available on all models. Styles may vary.

HARNESS - COMFORT MODE (NO BUCKLE COVER)
When using buckle strap in Comfort Mode with no buckle cover, adjust buckle strap to highest position and thread under comfort mode webbing.

Using Your Stroller with Recommended Infant Car Seats

DEATH or SERIOUS INJURY can occur.

• Make sure the infant car seat is securely attached into the seat mounts on both sides of the stroller before placing child in the seat.
• Only use Evenflo SafeMax™, LiteMax™ and LiteMax™ Sport infant car seats with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and if used with this stroller, may result in serious injury to your child.
• To ensure safety for your baby, please refer to the manufacturer's instructions for the use of your recommended infant car seats and keep all instructions available for reference.
• DO NOT lift stroller by using the infant car seat handle when installed on stroller.
• DO NOT use infant car seat without child tray attached.

If unable to securely attach your infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink at 1-800233-5921 (USA), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).

1. Before inserting infant car seat onto stroller, child tray MUST be attached.
   To attach infant car seat to stroller seat, fully recline stroller by squeezing button on the recline strap and lowering the backrest.
   
2. Insert infant car seat into stroller parent-facing until it latches into the infant car seat attachment points as shown.
   The infant car seat MUST be facing the parent when installed.
   
3. Pull up on the infant car seat to make sure it is securely attached to the stroller.
   
4. To remove, squeeze handle on rear of seat and pull infant car seat up off of the stroller.
   

Clover Use Configurations

Care and Maintenance

• Clean minor spills and stains on cloth or plastic surfaces with cold water and mild soap. Air dry.
• Metal and plastic parts can be wiped clean with a soft damp cloth and dried with a soft cloth.DO NOT use abrasive cleaners or solvents.

WARNINGS

Read all instructions before assembly and use of product.
KEEP INSTRUCTIONS FOR FUTURE USE.

DEATH or SERIOUS INJURY can occur.
Read and follow all warnings and instructions. Failure to do so could result in serious injury or death.

• Only use Evenflo SafeMax™, LiteMax™ or LiteMax™ Sport infant car seats with this stroller. Other infant car seats or carriers are not designed to fit the stroller frame and if used with this stroller, may result in serious injury to your child.
• NEVER leave child unattended. ALWAYS keep child in view while in the stroller.
• Adult assembly required. Take care when unpacking and assembling; contains small parts and some items with sharp edges.
• To prevent a possible choking hazard, remove and discard packing material before using this product.
• Avoid serious injury from falling or sliding out.ALWAYSuse waist restraint.
• DO NOT carry or roll stroller on stairs or escalators with child in it.
• DO NOT hang items on handle bar or place them on the canopy as they can tip stroller over and injure child.
• Be sure stroller is fully assembled and locked in unfolded position before using.
• ALWAYS exercise care when going over curbs or steps, and never use stroller for anything other than transporting your child. Push stroller at a normal walking pace only; faster strolling can cause a loss of control and injury to the child.
• DO NOT place hot liquids in cup holder. Spills can burn you or your child.
• To avoid serious injury from child falling out of stroller,DO NOT raise, recline or convert seat to Comfort Mode with child in stroller.
• DO NOT use stroller if any parts are missing or broken.
• DO NOT allow child to climb on, into, out of, or around stroller.
• DO NOT allow child to stand on the footrest. Stroller may tip over and injure child.
• DO NOT carry additional children, goods, or accessories in or on this stroller except as advised in these instructions. The stroller is intended for use with one child and to accommodate only the additional weights in storage as listed in these instructions.
• Care must be taken when folding or unfolding stroller to prevent finger injury to you or your child in hinge areas. Make sure child is not in the seat or near the stroller when folding or unfolding.
• NEVER leave stroller on a hill or incline, even with brakes set. Stroller may tip, injuring the child.
• To avoid accidental rolling,ALWAYS set brakes when stroller is not being pushed.
• AVOID STRANGULATION:
  • DO NOT suspend strings or toys from the canopy.
  • DO NOT place stroller anywhere near cords from window blinds, draperies, phone, etc.
  • DO NOT place items with a string around your child's neck such as hood strings or pacifier cords.
  • If not properly secured, the child may slip into leg openings and strangle.
• When making adjustments to the stroller,ALWAYS ensure that all parts of the child's body are clear of any moving parts of the stroller.
• The canopy is not intended to provide UV protection.
• Sharp or heavy objects placed in pockets may cause damage to the stroller, or injury to the child.
• To ensure safety for your baby, please refer to the manufacturer's instructions for the use of your recommended infant car seats and keep all instructions available for reference.
• To avoid stroller instability and tip-overs,DO NOT load child tray with over 1 lb (0.45 kg), parent tray with over 2 lbs (0.90 kg) and the main cargo basket with over 10 lbs (4.5 kg).
• DO NOT lift stroller by using the infant car seat handle when installed on stroller.
• Make sure the infant car seat is securely snapped onto the car seat mounts.
• DO NOT use Comfort Mode with a child over 6 months of age.
• ALWAYS remove child tray when using stroller in Comfort Mode.
• ALWAYS thread lower harness strap under webbing when child is in Comfort Mode.
• NEVER attach infant car seat with child in Comfort Mode.
• NEVER use seat in the Comfort Mode position unless the seat is set up in Comfort Mode as per the instructions.
• NEVER use the stroller in any configuration other than what is shown in the instruction manual.

If unable to securely attach the infant car seat to this stroller, remove the car seat and contact Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico).

Important Information

Child Requirements

• Maximum weight: 50 lbs (22.7 kg), Maximum height: 40 inches (101.6 cm)
• Comfort Mode: Intended for a child up to 6 months of age.
• Stroller Mode (in upright position): Intended for a child who is capable of sitting upright unassisted.

Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble the stroller according to these instructions. If you are missing parts, do not use stroller and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.), 1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico) to order replacement parts.

Registration Information
Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your personal information. To register your product, please complete and mail the card that came with it or visit our online registration at www.evenflo.com/registerproduct.
For future reference, record the Model Number and Date of Manufacture below. You can find this information on one of the rear stroller legs.
Model Number:
Date of Manufacture: