Table of Contents
Advertisement
5.4
Installation
NOTE
The devices have been prepared for installing in flush-mounted boxes in
connection with the corresponding mounting plate. The device insert has already
been inserted in the mounting plate.
To install the device, perform the following steps:
Hinweis
The sensor must be pulled off the flush-mounted insert before mounting!
Hinweis
Observe correct wiring!
Abb. 7:
Connection and installation
Fig. 8:
Mounting the cover
Fig. 9:
Mounting the cover fame
System Manual 2CKA001473B9186
Connection and installation
1. Turn the device into the correct
installation position [1].
2. Connect the 230 V power cord to the
bottom terminal block [2].
Observe see chapter "Circuit diagrams"
on page 16.
3.
Insert the device into the flush-
mounted box and screw it on.
4. Attach the cover (rocker; example
shows only a 1gang rocker) to the
sensor.
5. Mount the cover frame.
│17
Advertisement
Table of Contents
