Operation And Important Riding Points; Starting The Engine - Yamaha MT10M 2020 Owner's Manual

Operation and important riding points

1
Read the Owner's Manual carefully to
become familiar with all controls. If
2
there is a control or function you do not
understand, ask your Yamaha dealer.
3
WARNING
4
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
5
or injury.
6
7
8
9
10
11
12
EAU15952
TIP
This model is equipped with:

a lean angle sensor. This sensor
stops the engine in case of a vehi-
EWA10272
cle turnover. If this happens, the
engine trouble warning light will
come on, but this is not a malfunc-
tion. Turn the vehicle power off
and then back on again to cancel
the warning light. Failing to do so
will prevent the engine from start-
ing even though the engine will
crank when pushing the start
switch.

an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start switch
to restart the engine.
EAUM3632

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:


1. Turn the key to "ON" and make
7-1
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
See page 5-28 for more informa-
tion.
sure that the stop/run/start switch
is set to " ".
The following warning lights and
indicator lights should come on for
a few seconds, then go off.

Oil pressure warning light

Engine trouble warning light

Coolant temperature warning
light

Shift indicator light

Steering damper warning light

Traction control system indica-
tor light

Cruise control indicator lights
EAU74651