Yamaha YZ250 2022 Owner's Service Manual page 59

1. Clamp
2. Throttle position sensor lead
3. High tension cord
4. CDI unit band
5. CDI unit
6. CDI unit lead
7. Joint connector
8. Connector cover
9. Radiator hose
10.Radiator breather hose
11.CDI unit stay
A. Clamp the wire harness protecting tube to the
right engine bracket. Do not cut the end of the
clamp.
B. Pass the high tension cord to the right of the
radiator hose so that the high tension cord
does not contact the radiator hose.
C. Do not clamp the bare wire of the engine stop
switch.
D. Pass the CDI unit lead between the frame
and the radiator (right) and then above the
radiator fitting boss.
E. Face the joint connector with its open end
downward, and there is no pinching with
peripheral parts.
F. Bring the connector cover into contact with
the coupler.
G. Pass the radiator breather hose behind the
radiator hose.
H. Insert the CDI unit band until it stops at the
CDI unit stay.
CABLE ROUTING DIAGRAM
2-20