Yamaha YZ250 2022 Owner's Service Manual page 31

on.
ECA25821
NOTICE
After a break-in or after each race, always
check the points shown in "TORQUE-
CHECK POINTS" for tightening torques and
retighten them.
Also when the following parts are replaced, a
break-in is required.
• Cylinder and Crankshaft: A break-in is re-
quired for about an hour.
• Piston, Piston ring, Valve, Camshaft, and
Gear: A break-in is required for about 30
minutes at a throttle opening of 1/2 or less.
Observe the condition of the engine carefully
during a break-in.
For checkpoints for a break-in, see "MAIN-
TENANCE AFTER BREAK-IN". If any prob-
lem is found, immediately stop the engine
and make a checkup.
STARTING AND BREAK-IN
1-19