Advertisement
3-
WARNING SIGNS AND SAFETY DETAILS
3.1 Warning Signs
Power Network
Grounging
The machine should never be exposed to direct sunlight.
The machine should never be left in water and its outer surface should never be cleaned with high pressure
water.
This machine is designed for industrial use and should only be operated by personnel trained
according to this manual.
This machine must be installed according to effective regulations. It should only be operated
in places that are ventilated well or under a chimney hood. Otherwise, hot water steam and
excess moisture produced by your machine or other devices within the kitchen may damage
the mechanical and electrical parts of your machine. Ambient humidity should not exceed
65%.
Ambient temperature where the machine is operated should be between (+5 °C / +40 °C).
If the machine is fed with hot supply water, water inlet temperature should not exceed maximum + 50 °C.
The machine is designed to operate with softened water at a French water hardness level of (0 -10). Excess
calcium in water supply may damage moving parts of the machine and decrease washing performance of the
machine. For this reason daily maintenance as described in the section (CLEAN-UP AND MAINTENANCE Page
-18) should be carried out regularly.
The machine should not be dislocated when operating.
If the machine has to be operated subsequently, then it should be paused for 1 hour for every 4 hours of
operation.
OUR COMPANY IS NOT RESPONSIBLE FOR POSSIBLE FAILURES THAT MAY OCCUR AT DETERGENT SYSTEM
CONNECTIONS. THEREFORE WE RECCOMENT YOU TO COOPERATE WITH PROFESSIONAL DETERGENT
COMPANIES EMPLOYING ELIGIBLE INSTALLATION PERSONEL.
LOW QUALITY DETERGENT MAY HARM OPERATING SYSTEM AND PLASTIC COMPONENTS OF THE DEVICE.
THEREFORE WE REMIND YOU TO CHOOSE APPROPRIATE TYPE OF DETEREGENT.
WE DO NOT USE CLEANING CHEMICALS CONTAINING LAUNDRY WATER, CHLORIDE OR SODIUM
HYPOCHLORITE.
CLEANING MATERIALS MUST NOT BE USED AS STEEL SPONGE AND WIRE BRUSH.
WE RECCOMEND YOU TO TREAT THE SUPPLY WATER IN A PURIFICATION SYSTEM BEFORE USING, IF IT HAS A
HARDNESS HIGHER THAN 0 - 10 FRENCH HARDNESS LEVEL.
Electrical Connection: 380-415 V ~ 3NPE/50 Hz or 380-415 V ~ 3NPE/60 Hz
Your dishwasher can be one
Electrical Connection: 220 V-240 NPE/50 Hz or 220 V -240 NPE/50 Hz
of the values that given at right
side, for actual value of your
dishwasher please control your
dishwasher's nameplate.
Grounding
Electricity
Attention
+5 °C / +40 °C
Important
6
Advertisement
