Advertisement
4.8 Washing and Rinsing Water Temperatures
Water temperatures can be adjusted. During production, our appliance is set to the following temperature values. The
temperature should not be set higher than these temperatures.
Models:
Rinsing Water Temp.(Boiler)
Washing Water Temp.(Tank)
Machine Assembly
4.9. Measures on the Customer Side:
1- Call a qualified electrician to complete the electrical connection of the appliance. A V-type
automated fuse located at a minimum height of 120 cm, and a 30 mA residual current device
should be installed in the assembly.
2- Ground the appliance with the mains ground lead securely attached to the ground terminal
of the appliance's power cable.
3- The appliance is delivered with a power cable (5x2.5 mm NYAF), an inlet hose with a 3/4"
tap connector and a Ø42 mm drain hose (Ø28 mm for the models with a drain pump).
4- To supply clean water to the appliance, install a new 1/2"piping system on the rear wall at a min. height of 200 mm
from the floor and terminate it with a 3/4" valve.
5- To discharge wastewater from the appliance, install a Ø50 PVC piping system on the rear
wall at a max. height of 100 mm from the floor. Use a floor trap if the drain outlet is equipped
with a grate.
6- Make sure that there is a hood-equipped ventilation system in the room where the
appliance is installed.
7- Appliance's legs are adjustable. Adjust them to create a level plane on the floor.
8- Make sure that the room is free of steam and moisture.
Unless customer completes these measures, the authorized service will not install the appliance.
4.10. Measures on the Authorized Service Side:
1- After initial measures are completed by the customer, the service member called will install electrical and water
connections and start up the appliance.
2- Never start the appliance before the service member arrives, otherwise product warranty will be void.
3- Call the detergent company on the day appliance is installed, if possible. Have detergent and polisher pumps
installed. Our company or service will not be liable for any damage on the appliance caused by the detergent company.
HW-600B3 RT
80-85°C
55-66°C
"
"
Grounding
connection
CAUTION! : NEVER START THE EQUIPMENT
BEFORE GROUND CONNECTION IS
COMPLETED
screw for an external
11
Advertisement
