Kenwood TM-201B Instruction Manual page 7

2m fm transceiver

Hide thumbs Also See for TM-201B:

REV switch

Used to reverse the repeater shift (+600 kHz) to monitor the repeater input.

REV

Setting this switch to ON in simplex operation locks the displayed frequency

regardless of VFO, keyboard, and COM.CH operations.

TX OFFSET switch

Used to select the transmit frequency offset (+600 kHz) for repeater use.

For other than of a repeater operation, place this switch to the ''S'' position.

This equalizes the transmit and the receive frequency.

"+"

setting shifts

+600 kHz;

''—"'

setting shifts

—600 kHz from

the

receive frequency when transmitting.

This operation is only effective in VFO and MR (M1~M3) operations.

If an offset frequency were to go beyond the operating frequency range when

depressing the PTT switch to transmit, a beep will sound three times to indicate

an error, and the radio will transmit simplex.

*With the optional TU-3 or TU-3A tone unit installed, either ''+'' or ''—"' set-

ting of the TX OFFSET switch connects the TU-3 or TU-3A 2nd tone frequency

setting.

@ REAR PANEL

ANT connector lead

Connect a 50-ohm antenna to this terminal.

DC Power Lead

DC power input lead. Connect the supplied power cord with plug. Input voltage

is 13.8 V DC.

Observe plus (+) and minus (—) polarity!

@® SP Terminal

Connect the supplied 8 ohm speaker to this jack.

@ RIGHT SIDE PANEL

Remote jack

Used to connect the optional FC-10 unit, controlling the operation frequency.