Kenwood TM-201B Instruction Manual page 6

@ HI/LOW switch
m Hi
|_—= |
om LOW
© Display
@)
S
Frequency display
Scan indicator
VFO B indicator
MR indicator
ALERT indicator
ON AIR indicator
BUSY indicator
S & RF meter
Photo is silver panel
HI setting: This setting causes the transmitter to transmit at approx. 45 watts.
LOW setting: This setting causes the transmitter to transmit approx. 5 watts.
(a) d @) f
2m FM TRANSCEIVER
Mo 7 fm is a ia MR ALERT ON AIR
a
4 toll wus
(ge h
During VFO A or B, frequency, for example, 145.02 is displayed in four digits
as '' 5.020 ''. 5.028
During MR (M1 — M5) operation, frequencies, such as, 145.24 are
displayed in 4 digits as '5.240"'. S.24u
During COM* operation, frequency is displayed in four digits. At this time, zero
at the last digit is half size.
" European and British versions excluded.
During scan operation, this dot flashes.
In operations other than scan, this dot lights to show MHz.
Lights when VFO B is in operation.
Lights during memory recall operation (M1 — M5, MS).
Lights during alert operation.
Lights when transmitting.
Lights during reception with squelch opened.
This can be used to see if the channel is busy or not.
Indicates the incoming signal strength by LEDs during reception.
During transmission, LEDs light to show the RF output level strength.
With the HI/LOW switch HI, al! LEDs light.
With the HI/LOW switch LOW, two to four LEDs light.