Kenwood TM-201B Instruction Manual page 16

(2) Programmable scan
16
144.5 8
During VFO A or B operation, depressing and holding the mic UP or DWN
switch for 1 second will initiates scan programmed within the range set bet-
ween receive and transmit frequencies designated in memory channel 5.
144.0 Upper limit
Lower Up scan
limit
Down scan
ii) When VFO is at point B, scan starts as shown.
T
Up scan Down scan
As shown in the figure, R denotes the receive frequency in CH 5; T denotes the
transmit frequency in CH 5.
i) When VFO is at point A, scan starts as shown.
iii) When R and T are equal, scan operates through the whole frequency
range.
Procedure Operation Indication
1 | Scan range setting
Store lower and upper limit frequencies in
memory channel 5 by operating the M, M5,
tuning control UP, DWN or MHz switch.
2 | Scan start
Hold the mic UP or DWN switch depressed for
more than one second. The scan starts. The
megahertz dot starts flashing
°
Flashes
3 | Scan will stop at a busy station and resume in 6 seconds.
4 | Scan resume
Scan resumes regardless of signal when
operating the tuning control or UP/DWN
switch
5 | Rapid scan
Holding the UP/DWN switch depressed allows
rapid up or down scan.
Holding the MHz key depressed allows rapid
scan in 1 MHz steps.
6 | Scan direction
During up scan, depressing the DWN key or
turning the tuning control one click to the left
reverses the direction.
During down scan, reversing the above pro-
cedure reverses the direction.
7 Other scan range
operation
Holding the UP/DWN key depressed allows the
scan to go beyond the upper or lower frequency
limit
Example: During up scan from R to T, hold
the UP key depressed and allow the
scan to go beyond T. The scan goes
from T to R. (Outside the programm-
ed limits)
8 | Scan release
Depressing the A/B key or mic PTT switch
releases the scan.
The flashing dot will stop.
°
Lights