Kenwood TM-201B Instruction Manual page 11

e Antenna Installation
a a — a ai eae
Roof-top system Roof side system
aE CEN,
LO" & JO)
Front fender Trunk lid system
Installation for mobile operation.
Be sure to use a duplex mobile antenna.
Coax. cable routing
© Power supply
© Ignition noise
Various types of antennas for VHF mobile operation are available.
Note:
For gutter-mount installation, the antenna bracket must be grounded to the
car body as shown below. Affix the antenna securely, referring to the
antenna provided with your instructions.
Antenna installation
Antenna bracket
Remove the paint to in-
sure grounding to the
car body.
Pass through the rear
window.
fa)
Pass through the door fit-
ting. The cable can be in-
serted easily if the door
cushion is soft. Note that
rain water may enter
along the cable.
Lift the trim plate and
install the cable.
Connect the supplied power cable, with fuse, directly to the battery terminals.
Connecting to the cigarette lighter socket can cause a poor connection, and
excessive voltage drop.
insert through the firewall
Battery
To battery
Rubber grommet
mf y
Connect directly to the battery terminals.
The transceiver is designed to suppress ignition noise; however, if excessive
noise is present, it may be necessary to use suppressor spark plugs (with
resistors).
The PG-3A is available, should you requied additional filtering.
11