Kenwood TM-201B Instruction Manual page 14

oe
@ 16 key AUTO PATCH OPERATION
@ VERIFICATION BEEP TONE
14
To operate, hold the mic PTT switch depressed until after the first key has been
depressed.
Note:
1. After PTT operation is initiated, the transceiver will remain in transmit
mode even with the PTT switch released.
2. More than 0.8 seconds keying interval between digit entry will return
the radio to receive mode.
3. The touch-tone encoder level can be readjusted according to your re-
quirement.
When readjusting, set the deviation to 3 kHz by using the built-in VR (in
the mic.) with both the 3 and 6 keys of the encoder held depressed.
Next, hold both the 2 and 3 keys depressed to verify the deviation which
is within 1.2 kHz+0.3 kHz.
When operating, several beep sounds are provided to indicate operation. Beep
level can be adjusted by the potentiometer inside. (page 18)
Beep When beep will sound
Once When a key is operated correctly.
Twice When CH1 is busy during alert operation.
When ordering memory scan with all memory channels
Three times empty. When an offset frequency is out of operating
frequency range.
Four times When transmit frequency for odd split is not stored, the
repeatedly beep will sound until the frequency is stored.
Five times During REVerse operation
Eight times When memory is ready to be stored.
Once for approx. F
1.5 sec. When memory is stored.