Kenwood TM-201B Instruction Manual page 10

© Installation procedure
Fig. a Boss securing
oumm—{)) )—4}
Flat head - Boss Flat
screw washer
Be sure to use flat washers. However, when
stack installation with the TM-401B is at-
tempted, do not use these washers since the
stack plates are used.
Fig. c Mounting bracket installation
Mounting
surface
Flange nut
Flat washer
Spring washer
Hex. head bolt
Mounting bracket
these parts as shown.
10
Mounting surface
Mounting bracket
To install the bracket on a
bent mounting surface, bend
Example 2-7
—
Bracket 8 Sy
US
Speaker
1) Secure the bosses on each side with 4 flat head screws. (Fig. a)
2) Affix the cushion (c) on each side of the mounting bracket. (Fig. b)
3) Secure the mounting bracket to the chassis as shown in Fig. c.
When installing the bracket, be sure the front part of the bracket faces you.
4) Insert the transceiver as shown in Fig. d so the bosses on the transceiver
slide into the grooves of the mounting bracket.
5) To stack with the TM-401B (70 cm), first secure the supplied stack plate
to the TM-201B with bosses then stack the TM-401B, second insert the
stacked transceivers as shown in Fig. d so the bosses on the upper
transceiver slide into the grooves of the mounting bracket.
Fig. b Cushion attachment
Affix the cushion (C)
on each side.
Fig. d Transceiver installation
Transceiver installation
Ensure the front/rear of the bracket
when mounting.
Bosses
iS
Flat washer
Tapping screw
Mounting surface
TM-201B
Rear part of the
bracket.
Flat screw Stacking plate TM-401B