Master Body(Dc-S1R) Setting And Position - Panasonic LUMIX S-E2470 Service Training Manual

7.4.3. Master Body(DC-S1R) Setting and Position

7.4.3.1 Master Body(DC-S1R) Setting
- Cancel the Initial Setting
- Set the function parameter to below setting
7.4.3.2 Master Body(DC-S1R) Position
Place the Lens so that the center of the Checking chart come the
the center of the taking a picture screen of Master Body(DC-S1R).
Set the height of a tripod as the center of the Checking Chart
(1)
is corresponding to the height of the lens.
Set the position of DSC by using a setsquare etc.
(2)
Adjustment distance between the camera and Checking Chart
(3)
so that picture size and horizontal level in TELE end and WIDE
end is full display (camera LCD).
- The Guide line of the Checking Chart shall enter the upper
edge of the LCD screen.
- These adjustment execute in case of both TELE end checking
and WIDE end checking.
<WIDE end>
Checking
Chart
Move the Tripod to show expected frame of chart
on the LCD for both TELE end and WIDE end
About 960mm
Guide line of the Chart
<TELE end>
About 2800mm
28