Table of Contents
Advertisement
Available languages
Available languages
5.
Apply masking tape to the end of a 7 mm
nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
A
spud counterclockwise and lifting out. Set gas orifice spud
aside.
S|
6.
Replace with correct Natural gas orifice spud. See the
Burner orifice spud
"Natural Gas Orifice Spud/Hood Chart."
—
Use the following chart to find the exact orifice spud
placement.
A. Size stamp
Natural Gas Orifice Spud/Hood Chart
7.
Place LP gas orifice spuds in plastic parts bag for future use
Burner Rating
Size
Burner Style
and keep with package containing literature.
5,000 BTU
1.01 mm
Small burners
8.
Replace the burner base using both screws.
9.
Replace burner head and cap.
eee
10. Repeat steps 2 through 9 for the remaining burners.
oo
Complete Installation
15,000 BTU
1.75mm
Medium burners
1.
Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
2.
Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
20,000 BTU
1.89 mm
Large burner - main
IMPORTANT: You may have to adjust the "LO" setting for
0.69 mm
Large burner - simmer
each cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
4" (0.64 cm) to %" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. LP gas flames have a
slightly
yellow tip.
3.
Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
21
Advertisement
Table of Contents
