Table of Contents
Advertisement
Available languages
Available languages
To Convert Surface Burners
If installed, remove the burner grates.
Remove burner cap.
Remove the burner head.
NOTE: A "" socket must be used to remove the burner head
of the large dual burners.
Using a T15 Torx® screwdriver, remove the burner base.
Large Dual Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Gas opening
C. Burner base
Apply masking tape to the end of a 7 mm
nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
aside.
Replace with correct LP gas orifice spud. See the "LP Gas
Orifice Spud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
LP Gas Orifice Spud/Hood Chart
Burner
Color
Size
Burner Style
Rating
3,000 BTU
Blue
0.55 mm
Small burners
12,500 BTU
Brass
1.04 mm
15,500 BTU
Yellow
1.05mm
Large burner - main
Green
0.45 mm
Large burner - simmer
Burner orifice spud
A. Size stamp or color
Place Natural gas orifice in plastic parts bag for future use
and keep with package containing literature.
Replace the burner base using both screws.
Replace burner head and cap.
10. Repeat steps 2 through 9 for the remaining burners.
1.
2.
Complete Installation
Refer to the "Make Gas Connection" section for properly
connecting the range to the gas supply.
Refer to the "Electronic Ignition System" section for proper
burner ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
4" (0.64 cm) to %" (1.3 cm) long. The outer cone is not as
distinct as the inner cone. LP gas flames have a
slightly
yellow tip.
Refer to "Complete Installation" in the "Installation
Instructions" section of this manual to complete this
procedure.
19
Advertisement
Table of Contents
