Table of Contents
Advertisement
Available languages
Available languages
Flame Height
to adjust.
The cooktop flame should be a steady blue flame approximately
¥4" (0.64 cm) high.
Dual Flame Burner
A. Upper flame
B. Lower (simmer) flame
8.
Turn the control knob to LO and using a butane extension
.
lighter, light the burner.
Single Flame Burner
00
QO
O
O
O
0
9
0 0)
To Adjust Flame Height:
1.
Unplug range or disconnect power.
9.
Remove the control knob.
2.
Remove burner grates.
10. Use a 4%" x 4%" flat-blade screwdriver to adjust the flame
3.
Remove the control knobs.
height. Tighten screw to reduce flame height. Loosen screw
4.
Open the oven door and remove the 2 screws on each side of
to increase flame height.
the range that hold the control console in place.
NOTE: When you are converting to LP gas, the screw should
be tightened down completely.
ag
NOTE: Make sure to leave oven door ajar or the control
console will not rest in the side brackets properly once it is
A. Single flame burner adjustment screw (on right side of valve)
detached.
B. Dual flame burner adjustment screw (on left side of valve)
5.
Pullup on the control console and let it drop forward into the
a
a e
.
notched console brackets on each side.
11. When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that need
adjustment.
A. Control console bracket
6.
Remove the round gasket from the valve stem.
16
7.
Putacontrol knob onto the valve stem of the burner you want
Advertisement
Table of Contents
