Electrical Connection - U.s.a. Onniy 2 - Jenn-Air JDRP430WP00 Installation Instructions Manual

Electrical Connection - U.S.A. Only
30" (76.2 cm) and 36" (91.4 cm) Models 48" (121.9 cm) Models
a a
Electrical Shock Hazard Electrical Shock Hazard
Disconnect power before servicing. Disconnect power before servicing.
Use a new 40 amp power supply cord. Use a new 50 amp power supply cord.
Plug into a grounded outlet. Plug into a grounded outlet.
Failure to follow these instructions can result in death, Failure to follow these instructions can result in death,
fire, or electrical shock. fire, or electrical shock.
1. Disconnect power. mg Tighten strain relief screw against the power supply cord.
2. Remove the terminal block cover screws and disengage
mounting tabs to remove terminal block cover from back of
range.
4. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you willbe Go to Section:
connecting to:
A. Phillips head screws 4-wire receptacle A UL listed, 4-wire connection:
B. Terminal block cover (NEMA type 14-50R) = 250-volt Power supply cord
C. Two mounting tabs at bottom minimum,
CO 40- or 50-amp,
3. Add power supply cord strain relief. range power
m Assemble a UL listed strain relief in the opening. [| 1 [| supply cord
3-wire receptacle A UL listed, 3-wire connection:
(NEMA type 10-50R) = 250-volt Power supply cord
minimum,
40- or 50-amp,
range power
supply cord
A. UL listed strain relief
12