Table of Contents
Advertisement
Chapter 2 Getting Started
TS3420RS
10
11
18
1
Power Button
To power on the TeraStation, connect the power cable and wait for 10 seconds, then press the power button.
To power off the TeraStation, press and hold down the power button for three seconds.
If the TeraStation beeps, pressing and holding this button for a short period will stop the beeping.
2
Power LED
For the TS3220DN, TS3420DN, and TS3420DS TeraStation models, the LED glows green when the TeraStation is
on. For the TS3420RN and TS3420RS TeraStation models, the LED glows white when the TeraStation is on.
Note: If the LED continues to blink for longer than 15 minutes instead of turning into a solid glow, refer to the
"Power LED Keeps Blinking"
3
Info LED
If there is a status message, the info LED will light up amber. Check the Settings interface or NAS Navigator2 to
see the status message.
4
Error LED
If there is an error, the error LED will light up red. Check the Settings interface or NAS Navigator2 to see the
error message.
5
LAN1 LED
When LAN port 1 is connected, this LED glows green and blinks when the connection is experiencing activity.
6
LAN2 LED
When LAN port 2 is connected, this LED glows green and blinks when the connection is experiencing activity.
7
Function Button
Use this button for dismounting USB devices, rebuilding RAID arrays, configuring failover, stopping the
TeraStation's beeping, and initializing settings using a USB drive.
8
Drive Lock
Open the front panel with the key to replace drives or access the init button.
17
10 18 3 4 5 6
20
19
12
13 14
section in chapter 11 for more details.
2
10 1
7 10 9
21
16
17
12
15
11
Advertisement
Table of Contents
