Remove Packing Materials; Remove Storage Drawer - GE P2S975 Installation Instructions Manual
Self-cleaning dual fuel slide-in range
Hide thumbs
Also See for P2S975:
- Owner's manual (136 pages) ,
- Installation instructions manual (60 pages) ,
- Brochure (11 pages)
Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions
PRE-INSTALLATION CHECKLIST (CONT.)
[4] CAREFULLY, TILT RANGE TO
ACCESS RANGE LEVELING
LEGS
Use an adjustable wrench to screw leveling
legs out so that support flanges clear top of
countertop.
[5 | REMOVE THE DOOR IF
NECESSARY
Door removal is not a requirement for
installation of the product, but is an added
convenience. To remove the door:
[A]
UNLOCK HINGES
Push both hinge locks down toward the
door frame, to the unlocked position.
This may require a flat blade screwdriver.
Hinge
unlocked
position
POSITION
DOOR
Place hands
on both sides of the door, and
This is half way between the broil stop and
fully closed.
[5] REMOVE
THE
DOOR
IF
NECESSARY
(cont.)
LIFT OFF DOOR
Lift door up and out until the hinge arms
clear the slots.
DO NOT LIFT THE DOOR BY THE HANDLE.
NOTE: The oven door is very heavy. Be sure
you have a firm grip before lifting the oven
door off the hinges. Use caution once the
door is removed.
Do not lay the door on its
handle. This could cause dents or scratches.
Hinge clears slot
[6 | REMOVE PACKING
MATERIALS
Also remove labels on door, plastic on trim
and panel and all tape around the range.
close the oven door to the removal position.
REMOVE STORAGE DRAWER
[A] Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guides.
Pull forward and remove the drawer.
Advertisement
Table of Contents
Need help?
Do you have a question about the P2S975 and is the answer not in the manual?
Questions and answers
How to remove top to get at burner igniters
To access the burner igniters on a GE P2S975, follow these steps:
1. Ensure Safety: Turn off the gas supply and disconnect power to the range.
2. Remove Burner Caps and Heads: Lift off the burner caps and ensure the burner heads are properly positioned for removal.
3. Avoid Touching Electrodes: Be careful not to touch the electrodes while another burner is on to prevent electrical shock.
4. Lift the Cooktop: After removing the burner heads, carefully lift the cooktop to access the burner igniters.
Make sure all parts are reassembled correctly after maintenance.
This answer is automatically generated