Operation Checklist - GE P2S975 Installation Instructions Manual
Self-cleaning dual fuel slide-in range
Hide thumbs
Also See for P2S975:
- Owner's manual (136 pages) ,
- Installation instructions manual (60 pages) ,
- Brochure (11 pages)
Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions
INSTALL THE RANGE (CONT.)
OPERATION CHECKLIST
* Double check to make sure everything in
this guide has been completed. Rechecking
steps will ensure safe use of the cooktop.
® Make
sure all controls are left in the OFF
position.
® Make sure the flow of combustion
and ventilation air to the cooktop is
unobstructed.
e The serial plate for your Range is located
under the oven door above the storage
area. In addition to the model and serial
numbers, it tells you the ratings of the
burners and the type of fuel and pressure
the cooktop was adjusted for when
it left
the factory.
* When
ordering parts, always include the
serial number and model
number to ensure
proper replacement parts.
¢ Recheck Steps: Double check to make
sure everything in this guide has been
completed. Rechecking steps will ensure
safe use of the Range.
Please see L.P. conversion
instructions
supplied with this range when L.P. Gas
is used.
NOTE:
Instructions are mounted
on
regulator bracket.
16
Advertisement
Table of Contents
Need help?
Do you have a question about the P2S975 and is the answer not in the manual?
Questions and answers
How to remove top to get at burner igniters
To access the burner igniters on a GE P2S975, follow these steps:
1. Ensure Safety: Turn off the gas supply and disconnect power to the range.
2. Remove Burner Caps and Heads: Lift off the burner caps and ensure the burner heads are properly positioned for removal.
3. Avoid Touching Electrodes: Be careful not to touch the electrodes while another burner is on to prevent electrical shock.
4. Lift the Cooktop: After removing the burner heads, carefully lift the cooktop to access the burner igniters.
Make sure all parts are reassembled correctly after maintenance.
This answer is automatically generated