Important Safety Instructions; What To Do If You Smell Gas; Electrical Requirements - GE P2S975 Installation Instructions Manual

Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR SAFETY:
AWARNING — If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU
ar SMELL GAS:
*® Do not try to light any appliance. Do not
touch any electrical switch; do not use any
phone in your building.
¢ Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
e If you cannot reach your gas supplier,
call the fire department.
installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
FOR YOUR SAFETY:
AWARNING — For personal safety,
remove house fuse or open circuit breaker
before beginning installation. Failure to do so
could result in serious injury or even death.
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
protrudes at least 5" beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13".
Be sure your appliance is properly installed
and grounded by a qualified technician.
This range has been design certified by
UNDERWRITERS LABORATORIES for use in
the United States and Canada. You'll find
safety precautions in your Owner's Manual.
Read them carefully.
® Installation of this range must conform with
local codes or in the absence of local codes
with the National Fuel Gas Code, ANSI
2223.1-Latest edition.
* Be sure your range is installed properly by
a qualified installer or service technician.
¢ To eliminate reaching over surface burners,
cabinet storage above burner should be
avoided.
¢ Do not install the unit near an outside door
or where a draft may affect its use.
ELECTRICAL REQUIREMENTS
This appliance must be supplied with the
proper voltage and frequency and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse
having a recommended amperage rating per
the table below.
BREAKER OR FUSE SIZE
240V 40 Amps
208V 40 Amps
NOTE: Check Local Codes for required
breaker size.
Rating plate is located above the storage drawer
below the oven frame.
Rating
plate location
We recommend you have the electrical wiring
and hookup of your range connected by a
qualified electrician. After installation, have the
electrician show you where your main range
disconnect is located.