Setting The Amount Of Rinse Aid Added; Switching Off The Rinse Aid System; Cleaners; Suitable Cleaners - Bosch SMV2ITX23E Instructions For Use Manual

Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
Close the lid of the rinse aid
4.
reservoir.
aThe lid clicks into place audibly.
11.2 Adjust the amount of rinse
aid added
If streaks or water stains remain on
the dishes, change the amount of rinse
aid added.
press.
1.
To open the device settings,
2.
press.
a
flashes.
3.
press repeatedly until
flashes.
Press repeatedly until the
4.
appropriate amount of rinse aid
has been added.
ABC
0, 1, 2 or 3 LEDs light up
accordingly.
Level 2 is set at the factory (LED
A and LED B → Page 16 ).
– A low setting adds less rinse aid
to the wash cycle and reduces
streaks on the dishes.
– A higher level adds more rinse
aid to the rinse cycle, reduces
water stains and produces a
better drying result.
To save the settings,
5.
3 ek
Press seconds.
3 seconds
11.3 Switch off the rinse aid
system
If the rinse aid refill indicator bothers
you, for example if you use combined
detergents with a rinse aid
component, you can switch off the
rinse aid system.
Tip:The function of the rinse aid is
limited with combined detergents. If
you use rinse aid, you will usually
achieve better results.
press.
1.
To open the device settings,
2.
press.
a
flashes.
3.
press repeatedly until
flashes.
4.
Press repeatedly until there is no LED
→ Page 16 lights up (level 0).
To save the settings,
5.
Press for 3 seconds.
aThe rinse aid system is switched off
switches on and the rinse aid refill
indicator is deactivated.

1 2 cleaners

12.1 Suitable cleaners

Only use cleaner that is suitable for
dishwashers. Both solo cleaners and
combined cleaners are suitable.
To achieve optimal rinsing and drying
results, use solo cleaners in
conjunction with the separate
application of special salt → Page 24
and rinse aid → Page 26 .
Modern, powerful cleaners
predominantly use a low-alkaline
formula with enzymes.
cleanserde
3 seconds
27