Bosch SMV2ITX23E Instructions For Use Manual page 48

deTroubleshooting
Disturbance
Leftover food on dishes
dishes.
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
Traces of rust on surfaces
plug.
There are cleaning residues
in the detergent
chamber or in the
tab collecting tray.
48
Cause and troubleshooting
Adjust the upper dish rack to the same height on
▶
the left and right.
→ "Upper dish rack", page 21
The amount of rinse aid added is set too high.
Set the rinse aid system to a lower level.
▶
→
""Setting the amount of rinse aid added", page 27
No rinse aid is filled.
Add rinse aid.
▶
→
"Filling with rinse aid", page 26
Detergent residues are present in the rinse program section.
The lid of the detergent compartment was blocked by pieces
of crockery and did not open completely.
Place dishes in the upper dish rack so that the tab
1.
drip tray is not blocked by dishes.
→
"Putting away the dishes", page 31
The dishes are blocking the cleaner lid.
Do not place dishes or air fresheners in the tab drip
2.
tray.
Dishes have been pre-cleaned too much. The sensors
determine a weak program flow. Stubborn dirt
sometimes cannot be removed.
Only remove large food residues and do not pre-
▶
wash the dishes.
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
Use rust-resistant dishes.
▶
Cutlery also rusts if rusting parts are washed with it.
Do not wash rusty parts.
▶
Salt content in the rinse water is too high.
Remove any spilled special salt from the rinsing
1.
container.
Tighten the cap of the special salt container tightly.
2.
Spray arms were blocked by crockery and the
detergent was not rinsed out.
Make sure the spray arms are not blocked and
▶
can rotate freely.