Advertisement
. Insert the minus screw driver (large) into the groove on
the left side as indicated in Fig. 5-21 (B), and after moving
it into just below the ''gate boss"' of the front panel and
turning the tip of the screw driver at this Position, slowly
push up the front panel according to the precautions in
the step 3.
. Insert a size AA battery, etc. between the raised front
panel and speaker box as shown in Fig. 5-22
. Next, insert an acryl plate with a thickness of about! mm
toward the boss of the front panel provided at the center
of the surface on the left side.
. Insert another minus screw between the minus screw
driver and front penal as shown by the expanded part
in Fig. 5-22 in order to avoid damage to the front panel,
and push up the front panel to the front buffle/buckle
plate as a supporting point.
. Then,
remove
all of the
bosses
according
to the
procedures in the Steps 4 - 7.
. For dismounting the speaker unit, remove the four screws
to dismount
the low
and
medium
sound
zone
speakers
and the two
screws
to dismount
the
tweeter.
Boss
Front panel
Acryl plate
Front buckle
plate
Speaker box
Inset nut
Adhesive is used
Insert nut
UX-A5 A/B/E/G/GI/EN
©
i. Insert nut
é
-————\
Full range
speaker
Tweeter
Speaker box
Front panel
Insert a seize AA battery,
etc., for example
Acryl plate with a
thickness of approx.
1mm
Fig. 5-22
(No. 1857)
11
Advertisement
