Advertisement
UX-A5 A/B/E/G/GI/EN
@
Press the EDIT button once.
EDIT
soe
AUTOEDIT
Yy
D>
roecu
L
al
|
@ Press the EDIT button again.
iscibs
soe
AUTOEDIT
E>
=a
fafes]anl
fi
@
Insert a cassette with a suitable length (recording time)
with side A facing out.
© The tape length can be set from the remote control.
(See below.)
@
Press the CD SYNCHRO REC button to start CD edit
recording.
© Recording starts in the forward direction (on the side
facing out).
e During edit recording,
the leader tape section
(approx first 10 sec.) is wound automatically and
then recording starts. The reverse mode is set to
> mode automatically.
© The tape stops automatically when the CD has been
played.
© To change the tape length (recording time)
When the EDIT button is pressed with a CD loaded, the
tape length required to record the entire disc is
displayed (C-46, C-54, C-60, C-74 or C-90).
At this time, the displayed tape tength can be changed
by pressing the track number buttons.
Example: To change to C-50
Press the +10 button four times, and within 5 seconds,
press the 10 button.
When the length of the tape is changed, some of the tunes
that were to be recorded on side A may be indicated as to
be recorded on side B or vice versa, according to the tape
length specified.
Depending on the tape length specified, some tunes may
not be recorded on the tape. Set the tape length (recording
time) so that the entire disc can be recorded.
e@ When editing a disc with 16 to 20 tunes
CD editing can be used to record discs containing up to
20 tunes, however, the music calendar shows up to only
15 tunes.
As the 16th to 20th tunes will not appear in the music
calendar display (the "OVER?" indicator will light), be sure
to check the tunes you have recorded after completing
editing.
® Set the DOLBY NR as required. The | DOLBY NR
indicator lights.
Note:
The optimum sound quality will not be obtained if different
DOLBY NR switch settings are used during recording and
playback.
xvii
The tune numbers recorded on side B appear.
D0ge—_——_——___|
The tune numbers recorded on side A appear.
aa
Notes:
@ When a disc with 21 tunes or more is loaded,
"C---" will
appear in the display. In such a case, set the required
tape length using the track number buttons on the
remote control.
@ in CD edit recording blanks of approx. 4 seconds will
automatically be left between tunes on the recorded
tape.
When
automatic
spacing
between
tunes
is not
required ...
Perform the following.
1. Press the /il PLAY/PAUSE button of the CD player
twice. The CD Player enters the pause mode.
2. Press the CD SYNCHRO REC button to start recording.
Note:
e@ Depending on the disc used, blanks of a specified
length may be left between tunes
e After use
Press the M/CLEAR button to release the CD edit
recording mode. (The CD edit recording mode is also
released when the CD door is open.)
Advertisement
