Advertisement
UX-AS A/B/E/G/GI/EN
<CD Unit Section>
1. Remove the three screws '© retaining the CD P.C.
fl
e+ (11)
1c605
(In this case, the pickup P.C. board connector should also
be dismounted as necessary).
3. Remove
the two
screws
@
retaining
the CD
mechanism ass'y.
4. Raise the CD
mechanism
from the motor
side and
dismount
the mechanism
while
pushing
the rubber
cushion E section downward.
H@
Pickup Changing Method
1. Place the turntable of the mechanism ass'y while keeping
the table upside,
and remove
the two
screws
retaining the pickup cover (black).
2. Remove
the two
screws
(14) retaining
the plastic
controller, and unlock the section F.
3. Now, it is possible to dismount the pickup shaft and
change the pickup.
@ CD Door Dismounting Method
1. Dismount the CD door open sensor P.C. board.
2. Dismount and pull out the CD door shaft.
Mechanism
Holder
@
CD Clamper Dismounting Method
1. Under the conditions wherein the CD door is opened and
the clamper is drawn to the front side of the door, pull
the back side of the door. Next, slide the clamper to the
back
side
of the
door
where
the
click
has
been
disengaged. then, the clamper can be dismounted.
(No. 1857)
7
Advertisement
