Advertisement
Synchronized recording with the CD player
® inthis system, the CD player starts playback when the
cassette deck enters the recording mode.
Operate in the order shown
a
1 ape hi
le
0
a8
Oe
Load a disc and close the CD door.
Set to the CD mode.
leader tape before starting recording.)
exceed the tape length.
Select the required reverse mode( => or >
)
(oJ)
recording will start.
© Recording starts in the forward direction and CD play
starts automatically.
tunes, the deck stops automatically.
automatically left between tunes.
® To Stop recording in the middle, press the O (stop)
button of the cassette deck.
xviii
UX-A5 A/B/E/G/GI/EN
mode only)
if the tape is reversed while a CD is being played,
recording will be done on the reverse side of the tape as
follows:
* When less than 8 seconds of the last tune on the
forward
side
of the tape
have
been
recorded,
recording on the other side of the tape will start from
the beginning of the previous tune.
:
* When more than 8 seconds of the last tune on the
forward
side
of the tape
have
been
recorded,
recording on the other side of the tape will start from
the beginning of the current tune.
e To record an entire disc in the tune order of the
cD
After the operations in steps @ - © above, press the
[>I button of the CD player while pressing the O/88
REC and & buttons simultaneously.
Note:
e During CD edit recording and synchro recording, the
PAUSE and SEARCH buttons do not function.
Operate in the order shown
@
Load a cassette with side A facing out.
(Wind past the leader tape before starting recording.)
@
Select the required reverse mode{
= or =) ).
©
Select the source to be recorded.
TUNER:
Press the TUNER/BAND button. Tune to the
required station.
AUX: Press the AUX button.
@
Press the O/il REC button (recording-pause mode).
@ The tape direction indicator showing the side to be
recorded blinks.
@ The function switch is locked and its position cannot
be changed.
©
Press to start recording.
® To stop recording temporarily, press the C/I REC
button. To resume recording, press the [> or <J button
corresponding to the tape direction indicator which is
blinking.
Note:
e Recording cannot be performed on the side the tape
direction indicator of which is not lit.
Advertisement
