Advertisement
UX-A5 A/B/E/G/GI/EN
@
Procedures for Disassembly of Power Supply
=
Section
. Remove the two screws (@) retaining the rear panel.
. Remove the power sopply cord from the rear panel.
. Remove
the one screw
retaining
the amp.
input
(CD/tuner output) connector jack.
. Dismount
the upper power
supply
P.C. board
while
pulling it upward.
. Remove the four screws 6 retaining the head sinks A
and B.
. Remove the two screws 2) retaining the trans. bracket
from the bottom side.
@
Speaker Disassembly Method
This speaker is attached to the speaker panel and speaker
box by pressure bonding.
Since the panel, etc. may sometimes be damaged when
excessive force is applied rapidly to the panel, be sure
to apply force qradually to the panel, etc. to dismount
the speakey.
™
Speaker Box disassembly Procedures
1.
2.
3.
Manually remove the saran net (See Fig. 5-19).
Turn
the speaker
box
upside
down
as indicated
in
Fig.5-20.
Insert a minus screw driver (large) into the right groove
indicated in Figs. 5-20 and 5-21 (A), and push up just
the bottom of the insertnut.
10 (No. 1857)
. Slide the power
supply ass'y to the front side, and
dismount
it from the bottom
cover.
. Remove the one screw
retaining the power amp. P.C.
board.
. Remove the one screw @) retaining the power supply
relay P.C. board, and dismount this P.C. board from the
power supply trans. P.C. board.
Advertisement
