Specifications - Crown DBC NETWORK BRIDGE 137769-3 Operation Manual

DBC Network Bridge

7 Specifications

Audio
Dynamic Range
Digital Sampling
Frequency Response
Total Harmonic Distortion
Common Mode Rejection
Crosstalk
Maximum Input Level
Maximum Output Level
Analog Auxiliary Input Gain Range
Input Impedance
Output Impedance
Latency (analog, digital inputs)
A/D, D/A Converters
Digital Input
Network
DSP
Control Port
Power Supply
Monitor Output Logic Low
Monitor Output Logic High
Input Impedance
Input Logic Low
Input Logic High
Input Analog Range
Max Input Voltage
Operation Manual
> 108 dB (A-weighted, 20 Hz-20 kHz)
24-bit, 48 kHz
± 0.5 dB, 20 Hz-20 kHz
< 0.05% THD+N (1 kHz, 0 dBu)
50 dB at 60 Hz (typical)
> 80 dB at 10 kHz
+32 dBu (line) or +7 dBu (mic)
+20 dBu
+20 dB to –12 dB (add 25 dB for mic setting)
20 kilohms balanced, 10 kilohms unbalanced
100 ohms balanced, 50 ohms unbalanced
Analog: 1.13 mS. Digital: See Table 5 to the right
24-bit 96 kHz Cirrus Logic
AES/EBU, 24-bit, 32-96 kHz. Onboard sample rate converter
Onboard TCP/IQ, compatible with standard 100Mb Ethernet hardware
24-bit conversion with 32-bit, floating-point DSP processing
+5 VDC and +10 VDC outputs. Total output current 1 A.
< 0.1 V
10 V (via internal pull-up). Output current limited to 10 mA max per pin
> 50 kilohms
< 0.5 V
> 5 V
0 to 10 V (for inputs 9-16 only)
25 V
Table 5
Latency vs Sample Rate
Sample rate Latency
32 kHz 2.74 mS
44.1 kHz 2.36 mS
48 kHz 2.28 mS
96 kHz 1.81 mS
page 73