Crown DBC NETWORK BRIDGE 137769-3 Operation Manual page 46

DBC Network Bridge
5 Advanced Operation
CobraNet: Setup (continued)
Please refer to Figure 5.2.
7. IP Address
The Internet Protocol address that is assigned by the system integrator.
Used as a standard part of Ethernet networking transmission protocols and
works much like a zip/postal code for the unit on the network.
8. Conductor
The CobraNet 'Setup' tab indicates information about the status of the Con-
ductor (the CobraNet timing-master device). Each CobraNet device can be
assigned its own Conductor 'Priority' which will be used to determine who
will be the Conductor of the network. Conductor Priority values range from
0 to 255, with 0 being the lowest priority and 255 being the highest prior-
ity. A light indicates when the CobraNet device is the Conductor of the sys-
tem. The DBC Network Bridge defaults to 32.
9. Status indicators
There are a number of status and error indicators for the CobraNet network.
The Ethernet 'Status' tells if the physical network is connected to the unit.
The 'Rx Activity' and 'Tx Activity' lights tell if there is incoming or outgoing
Ethernet activity.
The Error Indicators are:
• Fault: An overall fault in the CobraNet network
• Receive: An error on received CobraNet Bundles
• Transmit: An error on transmitted CobraNet Bundles
• Mute: An audio output may be corrupt
• Clock: Fault or lost contact with the CobraNet network
• Display: Encountered an unexpected error
Figure 5.2 CobraNet Setup Window
page 46 Operation Manual