Booth Monitor Source Select - Crown DBC NETWORK BRIDGE 137769-3 Operation Manual

DBC Network Bridge

4.7.9 Booth Monitor Source Select

In the Signal Path window, click on the Booth Monitor
6
Source Select button to open the Booth Monitor
Source Select window (Figure 4.15).
The controls in this window allow you to adjust the level,
muting and polarity of selected output channels that feed
your booth monitor speakers. You can also select CobraNet
Bundles and Channels.
2
5
1. Input Selector Buttons
2. Level Slider
This slider adjusts the level of the selected channel.
3. Mute Button
Press this button to mute the channel. When muted, the
button turns green and displays a red X.
3 4
4. Polarity Button
Press this button to toggle + or – polarity for the selected
channel.
1
5. DBC Outputs Meters
7
6. CobraNet Bundle/Channel Selector
In this area you can set up Bundle numbers with arrow but-
tons, choose amplifier channels, and label the amplifier for
each monitor speaker.
7. Current Input Figure 4.15 Booth Monitor Source Select Window
This display shows the selected input channel. If an ampli-
fier channel 1 or 2 is selected, this display shows details on
its CobraNet setup.
page 36 Operation Manual