Yamaha WR450FN 2022 Owner's Service Manual page 121

Spring preload adjusting positions
Minimum
Position in which the spring is
turned in 1.5 mm (0.06 in) from
its free length.
Standard
Position in which the spring is
turned in 10.0 mm (0.39 in) from
its free length.
Maximum
Position in which the spring is
turned in 18.0 mm (0.71 in) from
its free length.
TIP
• Be sure to remove all dirt and mud from around
the locknut and adjusting ring before adjust-
ment.
• The length of the spring (installed) changes 1.5
mm (0.06 in) per turn of the adjusting ring.
b b
e. Tighten the locknut.
Rebound damping
ECA24370
NOTICE
Do not turn the adjuster forcibly beyond its
adjusting range.
1. Adjust:
• Rebound damping
a. Turn the adjuster "1" in the direction of "a"
or "b" to make an adjustment.
Direction "a"
Rebound damping is increased (sus-
pension is harder).
Direction "b"
Rebound damping is decreased (sus-
pension is softer).
* With the adjusting screw fully turned in di-
rection "a"
TIP
Although the total number of clicks of a damping
force adjusting mechanism may not exactly
match the above specifications due to small dif-
ferences in production, the actual number of
clicks always represents the entire adjusting
range. To obtain a precise adjustment, it would
be advisable to check the number of clicks of
each damping force adjusting mechanism and
to modify the specifications as necessary.
c c
Compression damping (for fast compres-
sion damping)
ECA24370
NOTICE
Do not turn the adjuster forcibly beyond its
adjusting range.
1. Adjust:
• Compression damping (for fast compression
damping)
a. Turn the adjuster "1" in the direction of "a"
Direction "a"
Compression damping is increased
(suspension is harder).
Direction "b"
Compression damping is decreased
(suspension is softer).
3-31
Rebound damping
Minimum (soft)
30 click(s) in direction "b"*
Standard
8 click(s) in direction "b"*
Maximum (hard)
0 click(s) in direction "b"
or "b" to make an adjustment.
CHASSIS
a
b
1