Installation Of The Motor; Positioning Of The Motor - V2 FORTECO 2500-I Manual

230v electro-mechanical irreversible rack actuator for sliding gates up to 2500 kg

Hide thumbs Also See for FORTECO 2500-I:

Table of Contents

3 - INSTALLATION OF THE MOTOR

PREPARATORY STEPS

CAREFULLY OBSERVE EUROPEAN REGULATIONS EN12445 AND EN12453 (WHICH REPLACE UNI 8612).

Always check the following:

• Your gate should have a strong and suitable build; no wickets should be present on the sliding gate.

• The sliding gate should not tilt excessively during its entire run.

• The gate should be able to slide freely on its guiding surface without an excessive friction.

• Install both closing and opening limit switches, in order to prevent the gate going off the guiding surface.

• Remove any manual locks.

• Bring power cable ducts near the bottom of the gate (diameter 20 / 30 mm) and of the external devices

(photocells, flasher, key selector).

To fix FORTECO, follow the instructions below:

1. use the measurements indicated in the drawing for the foundations

2. Arrange for one or two pipes for the passage of electric cables

3. Assemble the 4 clamps on the anchoring plate and fix them with the 4 bolts issued with the motor

Table of Contents